DNP Supernova Flex Installation Manual download pdf (Page 13)

E11 Powering up (Plug in)

PRESS

to

BEGIN

Insert the plug of the IR receiver cable into

the mini-jack socket in the screen (located

next to the RS-232 socket). See below.

Place the infrared eye in the metal holder and

ensure good visible contact to the remote

control can be obtained.

Plug the power cord into the screen- and wall

sockets.

a. After plugging in the power cord,

• press the House symbol to go to the

“Home page” then press [SN Flex] to

begin

13

Then

PRESS

• then press [UP] on the remote

b. The screen calibrates by automatically

moving down 3” [76 mm] and then to the

top position.

c. Press [DOWN] and the screen will roll

down to the factory set bottom position.

d. If the screen is not in the top position when

plugging in, Press [UP] & the screen will

move down 3” [76 mm] and slowly back up

to the top.

e. There will be a delay before screen

movement occurs after pressing the

button.

f. See section F for setting a new bottom

position.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Comments to this Manuals

No comments