DNP Supernova Flex Installation Guide download pdf (Page 6)

Installation guide

dnp Supernova™ Flex Classic

2. Attach Plate.B to Plate.C using Screw.D. Measure the distance between the two Plate.A pieces (installed on the wall in the

previous step) and space the Plate.B pieces the same distance apart then tighten Screw.D.

Note: Plate.C (x2) are not in the parts kit. They are already installed in the groove of screen case.

Plate.C

Screen case

Plate.C

Screw.D

Screw.G

Plate.B

Ensure that all Screw.Ds are tightened securely

Screen installation on wall

Make sure that you are at least two

people to do the screen installation.

1. Attach Plate.A to the wall using appropriate fasteners (Screw.F can

be used). Measure the length of the screen case and install the

plates far enough apart so that the plates will be near the ends of

the screen when it is installed. We recommend that the center of

Plate.A is not further than 200 mm from the end of the screen case.

The plates must be lined up parallel to each other to ensure proper

operation of the screen.

Wall

Safety wire

Safety screw

Screw.E

Wall

Screw.F

Plate.A

Slide

Wall

Screw.G

Screen case

Plate.A

Plate.B

(For installation on ceiling, please go to page 8)

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

No comments

DNP Supernova Flex Installation Guide Page 6